loading
reading
writing
saving
searching
Ender 5 S1 3D printer - $125
QR Code Link to This Post
Build volume: 220mm x 220mm x 280mm
Firmware: Klipper
USB C port works well with Klipper host running on a Raspberry Pi (not included but I am glad to give a copy of config files)
SD card slot works well
The hot end fan connector on mainboard does not work - replaced the fan and wired to use an external psu for it to run all the time
Will need new ptfe tubing from filament sensor to print head
Added additional vertical rods, bearings and holders for more stable build platform
BIGTREETECH ADXL345 V2.0 Accelerometer Board mounted on print head for input shaping
Microsoft webcam mounted to frame for video or jpegs of prints